Inspection & Maintenance Basic Monitoring Unit

• Keep ScanTool in Shop with Emissions-Mate Deployed in Vehicle
• Continuously Scans Vehicle with Immediate LED Updates
• No Complicated LCD Menus to Control during a Drive Test
• Ensure Monitors are Complete before Starting an Inspection
• Increase Daily Number of Inspections which can be Completed

Emissions-Mate Features

• Audible Beep Tone on a Monitor Change
• Bright Red / Green LEDs for Each Monitor
• Scans and Indicates if any DTCs are Present
• USB 2.0 Full Speed Interface allows Firmware Maintenance
• Low Power Sleep Mode allows Long Term In-Vehicle Installations
• Runs Mode 6 Monitors and Displays Composite Results
• Wide Temperature Range Operation for Harsh Environment
• ScanTool Interface Pass-Thru Support using USB Connector*

Mode 6 Pending Codes Status Support

• Performs Mode 6 Pending Codes scan and Displays the Composite Result
• Mode 6 Data Interpretation based on Vehicle OEM available with Mode 6 Software Application*

*Contact NEXTEK for Availability and your Custom Requirements

Autofix World : Emissions-Mate Review : February 2009

Basic Emissions Related Parameters

• Continuous and Non-Continuous Readiness Monitors
• DTCs (Diagnostic Trouble Codes)
• Mode 6 Pending Codes Status

Readiness Monitors : Supported and Completion Status

• Misfire
• Fuel System
• Comprehensive Component
• Catalyst
• Heated Catalyst
• Evaporative System
• Secondary Air System
• A/C System Refrigerant
• Oxygen Sensor
• Oxygen Sensor Heater
• EGR System
• Warm-Ups

Additional Emissions-Mate Options

• “Ready” LED provides Custom Display based on State Mandated Requirements*
• SDK Available for Custom Software Applications to perform OBD Communications to vehicle through Emissions-Mate USB Port*

Emissions-Mate Technical Information

Emissions-Mate Specifications Sheet [Download PDF]

Registration Information

Warranty Information

Mode 6 Tutorial

Mode 6 Advanced