|
- General -
Power Requirements:
Enclosure:
User Interface:
USB Interface:
Firmware Upgrade Support:
HandHeld Dimensions:
Cable Length:
Weight:
Environmental:
- Scanning/Display/Power -
Microcontroller:
LED Drivers:
Power Supply:
- ESD/Transient Protection -
DLC Pin 16:
DLC Pins 2,10,7,15:
DLC Pins 6,14:
USB Cradle D+/D-:
USB Cradle Pwr/Gnd:
- Vehicle Interface -
Supported OBD2 Modulations:
Supported OBD2 Protocols:
|
------------------------------------------------------------
12VDC @ 7.5mA typ (Idle - Sleep)
12VDC @ 150mA typ (OBD Active - Monitoring)[1]
ABS Plastic : Black color
Power/Status LEDs -> Red/Yel/Grn
General - Power, Ready
Continuous - Misfire, Fuel Sys, Comprehensive, DTCs, Mode6
Non-Continuous - Evap, EGR, O2 Sensor, O2 Sensor Heaters
Catalyst, Heated Catalyst, A/C System
Secondary Air, Warm-Ups
v2.0 Compliant : Full Speed (12MBits/s)
Type-B (Peripheral) Connector
Bus powered device @ 500ma peak
Flashable program memory via USB Connector
3.2”W x 4.8”H x 1.0”D
approx 6’
approx 22 oz
-25 to +70 Deg C temp ambient
20% to 90% RH, Non-Condensing
[1] Average power reqt based upon typ monitoring
profile running VPW protocol on GM
------------------------------------------------------------
Microchip PIC18LF4585 @ 16MHz Fosc
TLC592x based with 16 bi-color LEDs @ 15ma constant
current drive typical per diode
LM2694 based high efficiency switching regulator
@ 90% power efficiency typical
------------------------------------------------------------
Transorb @ 600W peak pulse - 35Vbr nom - 48V @ 12A max clamp
Varistor @ 0.1J non-repetitive surge - 65V @ 2A max clamp
Diode @ 6kV HBM ESD non-repetitive pulse
ESD Suppressor - IEC 61000-4-2 Direct&Air Discharge
Varistor @ 0.1J non-repetitive surge - 17V @ 1A max clamp
------------------------------------------------------------
VPW,PWM (SAE J1850)
NRZ UART (ISO 9141, KWP 2000)
CAN (ISO 11898)
ISO 9141-2 (ISO9141)
ISO 14230-4 (KWP2000)
ISO 15765-2 (FlowControl CAN)
|
